Skip to content
LawnElm

Trees

Tree trimming: when to prune, what to avoid and who should climb

Pruning is a small cut made for a reason. The risk is not in the cut but in the ladder, the saw and the power line above it, which is why the line between DIY and hiring is drawn by height and hazard.

By LawnElm Editorial Team Updated 8 min read

Priced by
The tree or the hour
Season
Mostly late dormant season
Do it yourself?
Partly, small trees only
Illustration: a tree with three pruning cuts marked just outside the branch collars

Short version

Prune with a reason, cut just outside the branch collar, and skip topping. Late winter before growth starts is the usual window for most trees in the cool belt, but oaks, maples and fruit trees have their own rules. Do small trees from the ground. Leave large trees, anything near a power line, and any job that needs a chainsaw above your shoulder to a licensed, insured crew; see tree service licensing and insurance for what to ask for.

What tree trimming covers

Crews use "trimming" and "pruning" for the same family of jobs. The International Society of Arboriculture (ISA) lists cleaning, which removes dead, dying, diseased, weakly attached and low-vigor branches, and reduction, which shortens a tree. The ISA page says no branch should be cut without a reason, so a good quote names the reason for each cut: safety, health, clearance or shape.

A reduction cut goes back to a side branch that can take over as the new end. ISA says that branch should be at least one third the diameter of the stem you cut. University of Minnesota Extension calls crown reduction the least desirable practice and says to use it only when it is absolutely necessary. Both sources draw a hard line against topping.

When to prune, by grass belt

Timing depends on the tree, not on the lawn, but the belt tells you which extension office to ask. ISA says routine removal of weak, dead or diseased limbs can be done at any time of year. Growth and wound closure are best when pruning happens before the spring growth flush, and heavy pruning of live tissue right after the flush should be avoided, especially on weak trees.

  • Cool belt. University of Minnesota Extension says late winter to early spring, while the tree is still dormant, is best for most pruning. Apples, crabapples, hawthorns and mountain ash go in late winter to early April; spring or summer pruning raises fireblight risk. Maples, walnut and birch relatives go after the leaves fully expand in late spring or early summer to limit sap bleeding. Spruce, fir and pines have their own windows. Spring-blooming shrubs such as lilac and forsythia are cut right after they bloom.
  • Oaks anywhere. Minnesota Extension says to avoid pruning oaks from April through October to reduce oak wilt risk. ISA gives the general rule: trees prone to diseases such as oak wilt should not be pruned during active transmission periods. Your state forestry or extension office knows the dates for your area.
  • Transition, warm and dry West belts. The sources read for this page do not give a published pruning window for these belts. The University of Arizona publication on hiring a tree expert does not address timing in the desert Southwest. Use the ISA rule above and ask your county extension office for the window for your species.

Calendar pages list tree work by month. Start with February or March to see what else is due in the yard at the same time.

Cuts that heal and cuts that do not

Minnesota Extension gives the cut location for a branch. Cut just beyond the branch collar, the swollen tissue at the base of the branch. Leave the collar intact and do not leave a stub. Wound dressing is not normally needed.

  1. For a limb too heavy to hold, make the first cut on the underside about 18 inches from the trunk, a third to a half of the way through.
  2. Cut from the top an inch or so further out until the limb falls free.
  3. Make the final cut from above, just outside the collar, and leave no stub.

The same publication ties the tool to the branch. Pruning shears handle cuts up to 3/4 inch, lopping shears up to 1 1/2 inches, and hand saws are for branches over 1 inch. Tri-cut saws go to about 4 inches. For maples, butternut, walnut and birch relatives, it says never to remove more than one quarter of the live foliage.

What a pruning quote should say

Tree crews quote by the tree, by the hour, or for the whole job. Size, height, access and distance to wires and buildings drive the number, and cleanup and haul-away are often separate lines. Virginia Tech Extension suggests three quotes and warns that a bid well below the others may mean the arborist does not understand the job. Pruning estimates should cover the same scope of work so you can compare them.

  • Which trees, and which cuts: for example, removing dead, dying, diseased and weak branches over a stated diameter. The University of Arizona gives 1.5 inches or greater as an example scope.
  • The standards the work follows. Arizona suggests naming ANSI A300 Part 1 (Pruning) and Z133 (Safety) in the contract.
  • Whether the crew uses climbing spikes. Virginia Tech says to ask, and Arizona says good arborists avoid spikes on a tree that is meant to stay.
  • Cleanup: who hauls brush, and whether you get firewood. Arizona's example says cut lengths of 16 inches.
  • Proof of insurance. Virginia Tech says to ask for current workers' compensation and general liability coverage. Arizona says you can confirm coverage with the insurer, which costs neither side anything, because an uninsured worker hurt on your property may leave you responsible.
  • For hourly work, a cap written as "but not to exceed" a total, which Arizona recommends.

Put the quote next to your own budget in the yard budget, which has a line for one-time jobs such as tree work. Ask for a written contract with scope, cost, property protection and timeframe, as Virginia Tech advises.

Power lines, ladders and saws

Electricity is the hazard that kills. Cal/OSHA's Tree Work Safety Guide says to always assume that power lines are energized and never to do tree work where any part of the tree, including leaves, is within 10 feet of high-voltage lines. Federal OSHA says employees who are not trained as line-clearance tree trimmers must stay at least 10 feet from overhead lines, and describes line-clearance tree trimmers as the workers trained to work within 10 feet of energized lines. Minnesota Extension's advice to a homeowner is shorter: do not prune near electrical or utility wires, and call the utility company.

  • Power lines are for the utility. Call the utility company about any branch near a wire, including the service line to your house. Do not lean a ladder or a pole saw on or near a line.
  • Ladders. Cal/OSHA reports that falls are among the most commonly reported tree work accidents. The agency says to consider an aerial device for trees that are unsafe to climb. If you do not have the equipment, that is a sign to hire a pro.
  • Chainsaws. Minnesota Extension says never to use a small chainsaw above shoulder height or while on a ladder. Cal/OSHA says to run a saw with both hands and to keep it below chest height, and warns that kickback is a major cause of injury.
  • Protective gear. Cal/OSHA's list for crews includes a hard hat, eye and hearing protection, heavy gloves, cut-resistant leg protection and safety boots.

Felling a large tree is the most dangerous job on this page. Virginia Tech calls it "a very dangerous proposition". Cabling, bracing and lightning protection should be installed by qualified arborists only. See tree removal and storm damage cleanup.

Licenses, insurance and digging

Tree work is licensed differently in each state. The Cal/OSHA guide says most tree work in California requires a D-49 Tree Service Contractor license from the Contractors State License Board. Virginia does not license arborists, according to Virginia Tech, so it suggests asking for the ISA Certified Arborist credential, which needs experience or education and a written exam. The University of Arizona page does not describe a general license requirement. ISA certification is a credential, not a state license, and Arizona adds that it does not guarantee good work.

Use the credential search on the ISA site to confirm a certificate number. Your state page notes any state or city licensing rules for tree care, and tree service licensing and insurance covers the questions in full. Stump grinding and root work can hit buried lines, so read call 811 before you dig first.

Mistakes to avoid

  • Topping, or hiring a crew that offers it.
  • Leaving a stub, or cutting flush with the trunk and removing the collar.
  • Pruning oaks in the oak wilt season for your state.
  • Heavy pruning of live growth just after the spring flush on a weak tree, which ISA says to avoid.
  • Paying a door-to-door crew that arrives with an offer you did not ask for, as Virginia Tech cautions.
  • Working from a ladder with a running saw.

Do it yourself or hire a crew

Virginia Tech's table sets a simple line. Trees under 20 feet tall are generally within a homeowner's capability, and trees over 20 feet, or any work near power lines, call for an arborist. Minnesota Extension says to leave large trees to qualified professionals with proper equipment, and to have hazardous trees removed professionally.

Small, dead twigs and low branches you can reach from the ground with hand tools are reasonable weekend work. A tree that touches a line, leans over the house, or needs a climber is not.

Questions people ask

When is the best time to prune a tree?

For most trees in the cool belt, University of Minnesota Extension says late winter to early spring while the tree is dormant. ISA says pruning before the spring growth flush gives the best growth and wound closure, and light removal of dead or weak limbs can be done at any time. Oaks, maples and fruit trees have exceptions.

Is topping ever acceptable?

ISA calls it perhaps the most harmful pruning practice known, and Minnesota Extension says to avoid it. If a tree is too tall, ask an arborist about reduction cuts to side branches, or about replacing the tree.

Can I trim a branch near a power line myself?

No. Federal OSHA sets a 10-foot minimum approach distance for workers who are not line-clearance trimmers, and Cal/OSHA says to treat every line as energized. Call the utility company, which handles branches near its lines.

What size tree can I prune myself?

Virginia Tech's guide says trees under 20 feet tall are generally within homeowner capability and taller trees call for an arborist. Reaching the branch from the ground with hand tools is the safe test.

Sources

Pruning timing, cuts and tool limits come from the extension and ISA pages above and were checked on November 20, 2026. Safety distances come from OSHA and Cal/OSHA, which write them for employers; they are quoted here as reasons to keep off lines, not as a method. Pruning windows for the transition, warm and dry West belts were not in the sources read, so ask your county extension office.